How to Install and Adjust the OfficeLogixShop Embody Headrest
Follow this step-by-step guide to install your Embody headrest properly. This process requires no tools and takes just a few minutes. Designed to match the Embody chair’s aesthetic and function, your new headrest will improve both comfort and support.
Tools and Components Needed
Tools Required: None
What's Included:
- Spine: with the metal gear preinstalled
- Headrest: fully padded ergonomic support
- Internal hardware: spring and nut
- Accessories: plastic cap and side cover
Installation Steps
| Step | Action |
|---|---|
| 1 | Inspect the spine to confirm the metal gear is in place and the nut is inside the plastic cap |
| 2 | Loosen the side bolt on the spine by hand and set it aside |
| 3 | Position the spine on top of the chair and press until it clicks securely into place |
| 4 | Push the side cover into position and reinsert the bolt to tighten by hand |
| 5 | Place the headrest on the spine, remove a bolt from the parts, and insert it through the opening |
| 6 | Insert the spring on the opposite side of the bolt |
| 7 | Click the metal gear into place with the threads facing inward |
| 8 | Install the plastic cap with the nut inside and tighten the bolt gently |
Adjusting the Headrest
- Loosen the central bolt to reposition the headrest vertically or change its tilt
- Once in the desired position, tighten the bolt by hand
Ongoing Use
- Side knobs should remain fully tightened during daily use
- If they loosen over time, simply re-tighten them manually
Installation Complete
Your OfficeLogixShop Embody headrest is now installed and ready to use. Make sure everything is aligned and secure for long-term comfort and ergonomic support.