How To Install the PostureFit on Your Aeron Chair?
Welcome to OfficeLogixShop's tutorial on installing the PostureFit support system to your Aeron chair. This addition will enhance your chair's ergonomic features, offering superior lower back support. Let's walk through the steps to successfully install the PostureFit system.
Tools Needed:
- Screwdriver
Installation Steps:
Attach the Chair's Back:
- Begin by aligning the chair's back with the frame.
- Secure it by inserting and tightening the four screws provided.
Disassemble the Cable Box:
- Locate the screw on the cable box underneath the seat.
- Unscrew to open the box, following the demonstrated method.
Hook the Bracket:
- Identify the bracket (the part not attached to the cable) and hook it under the seat for support.
Connect Cable to Bracket:
- Reattach the part with the cable to the bracket by aligning and screwing them together securely.
Access the PostureFit Mechanism:
- Remove the middle screw from the bottom of the chair's back.
- Proceed to unscrew and open the cable box once more, if necessary.
Create an Opening for the Cable:
- Carefully make an opening in the back's mesh right above where the middle screw was located.
- Slide the cable through this new opening.
Mount and Secure the Bracket:
- Position the bracket within the designated area and tighten it to ensure it's firmly in place.
Assemble the PostureFit System:
- Extend the cable and thread it into the PostureFit mechanism.
- Align the PostureFit on the rail, push it upwards, and then slide it down into its final position.
Finalize the Installation:
- Ensure all screws are tightened to secure the PostureFit system properly.
- Adjust the PostureFit to your liking for optimal support.
Conclusion:
Congratulations! Your Aeron chair now has the PostureFit installed, ready to provide you with enhanced back support for a more comfortable seating experience. Enjoy the improved ergonomics of your newly upgraded chair.