Steelcase Leap V2 헤드레스트 조절 가이드

Q: Why does my OfficeLogixShop headrest feel loose after I install it?

Once you install the OfficeLogixShop headrest for your Steelcase Leap V2 chair you might notice it feels a bit loose and moves freely up and down which is expected at first. Before you sit in the chair your first step is to tighten the adjustment bolts as much as you can.

Q: Will I damage the Leap V2 headrest if I tighten the bolts too much?

Do not worry about over tightening the bolts on your Leap V2 headrest. Even when fully tightened the headrest is designed to be adjustable with a bit of force because you want it firm so it holds its position and is not locked permanently in place.

Q: Where is the exact best place to rest my head on the Leap V2 office chair headrest?

The headrest works best when you push your head upward into the middle section. If you press your head against the very bottom edge the headrest may tilt downward so instead aim for the center.

Q: Is it normal for the OfficeLogixShop headrest to bounce when I lean back?

If you notice a bit of bounce in the OfficeLogixShop headrest that is completely intentional. It is designed to mimic the Leap V2 signature LiveBack technology so it moves with you just like the chair was meant to.

Q: How do I change the interchangeable insert on my Steelcase Leap V2 headrest?

To change the insert on your Steelcase Leap V2 headrest access the key lock and twist it from the vertical to the horizontal position to remove it then push up and away from the headrest to release the insert hooks.