How To Assemble the PostureFit SL on the Herman Miller Aeron Remastered Chair?
Welcome to our tutorial on assembling the PostureFit SL for your Herman Miller Aeron Remastered chair. The PostureFit SL system, designed to enhance the ergonomic support of your chair, includes two pads (top and lower) and an inner spine to connect them. This tutorial will guide you through the simple steps to assemble and attach the PostureFit SL to your chair, ensuring maximum comfort and support.
Tools Needed:
- Small Torx Bit Screwdriver
Assembly Steps:
Connect the Pads to the Spine:
- Begin with the two pads and the inner spine. You'll find indentations on the pads that are meant to clip onto the spine.
- Apply pressure to the pad into the spine's cavity until you hear a click, indicating the pad is securely attached. Repeat this process for the lower pad.
Attach the Y-Shaped Spine to the Chair:
- The bottom of the Y-shaped spine features cavities for screws that align with the holes in the chair's back frame.
- Align these holes with the cavities, then click the Y-frame into place from the sides. While ensuring the holes remain aligned, insert the screws and tighten them with the Torx bit screwdriver.
Insert the Inner Spine:
- Notice the small cavity on the inner spine and the accentuating part on the backside of the Y-spine. Insert the accentuating part into the cavity and slide it upwards to secure.
Final Adjustments:
- Clip the bottom part of the inner spine onto the chair's bottom. Adjust the tension by turning the knob located on the backside of the spine; forward to increase and backward to decrease the pressure.
The PostureFit SL Is Ready!
With these steps, your Aeron Remastered chair is now equipped with the PostureFit SL, ready to provide you with unparalleled back support and comfort. This simple addition can significantly enhance your seating experience.