Welcome to this Haworth Zody Headrest installation guide. This tutorial walks you through each step to complete the setup.
1. Disassemble the Bracket
- Locate the two screws on the inner side of the headrest spine.
- Remove both screws using a Phillips screwdriver to release the bracket.
2. Position the Headrest
- Center the headrest at the top of the chair, directly above the Haworth logo.
- Make sure it is straight before proceeding.
3. Install the Bracket
- Align the bracket with the dedicated rails on the headrest spine.
- Push the bracket upward until it is fully seated in place.
4. Secure the First Screw
- Insert the first screw into the bracket.
- Tighten it with the screwdriver until it is firmly in place.
5. Secure the Second Screw
- Insert the second screw and tighten it the same way.
- Make sure both screws are fully secured before moving on.
6. Adjust the Forward and Backward Position
- Push the headrest all the way forward to unlock the movement.
- Then move it backward to your preferred position.
- This serves as the lock, holding it in place when you rest your head on it.
7. Adjust the Height
- Press the button on the side of the headrest to move it up or down.
- Slide the bracket as needed to set the overall height.
8. Tilt the Cushion
- Tilt the headrest cushion upward for added comfort if desired.
9. Final Check
- Make sure the headrest is secure, comfortable, and adjusted to your liking.
- Your Haworth Zody headrest is now installed and ready to use.
Tip: Adjust the headrest height and angle until you find the most comfortable position for your neck and head.